Ez az oldal az Ön nyelvén jelenleg nem elérhető. Az automatikus fordítás a megtekinthető a Google Fordító segítségével. A szolgáltatás biztosításáért nem vállalunk felelősséget, a fordított szöveget nem ellenőrizzük.
Ha további segítségre van szüksége, lépjen kapcsolatba velünk.

RUP1 ultrasonic probe for the REVO® system

The RUP1 probe system makes automated thickness measurement an integral part of your CMM measurement procedure.

Ultrasonic thickness measurement on a 5-axis CMM platform

RUP1 ultrasonic thickness measurement

The RUP1 ultrasonic probe increases the multi-sensor capability of the REVO® system offering ultrasonic thickness inspection.

Unlike many other ultrasonic systems, RUP1 does not require the use of water tanks or coupling gel to enable a good transmission of the signal. Instead, it uses an innovative elastomer tip ball to provide excellent coupling between the probe and the material. As a result, the RUP1 probe eliminates the need for skilled operators to interpret oscilloscope screens and releases shop floor space occupied by the dedicated immersion tanks.

The use of ultrasonics for single-sided measurement of part thickness also delivers clear advantages over traditional tactile probing techniques for parts where access to internal features is challenging.

The RUP1 is fully integrated into MODUS™ metrology software (version 1.12) and UCCsuite (version 5.8).

Elastomere tip balls for RUP1

Aircraft landing gear parts, power generation drive shafts, and hollow aerospace blades are only a few parts that will significantly benefit from using the RUP1 system.

RUP1 ultrasonic probe and ball

RUP1 features and benefits

  • RUP1 ultrasonic probe is fully compatible with the MRS2 change rack and is automatically interchangeable with all other probes available for the REVO system.
  • The RUP1 probe uses a 20 MHz transducer and provides a thickness measurement range of 1 mm to 20 mm with an accuracy of better than 25 microns using touch points.
  • The use of an innovative elastomer tip ball provides excellent coupling between the probe and the material, and eliminates the need for water tanks or coupling gel to enable a good transmission of the signal.
  • Overcoming the need for skilled operators to interpret oscilloscope screens reduces costs.
  • The RUP1 ultrasonic probe is fully integrated into MODUS and UCCsuite metrology software, including features such as:
    • geometry and material calibration
    • tip ball size monitoring and compensation
    • automatic calculation of REVO head positions based on the back-wall angle for non-parallel surfaces
    • tip life monitoring
  • A standalone signal viewer is also available which provides experts with a graphical view of the measurements.

Technical specifications


Features
Characteristics
Material thickness range1 mm to 20 mm on typical metal parts (aluminium, steels and titanium).
Not supported are: parts made from cast iron, CF, GF, glass and additive materials, and those with coatings.
Thickness measurement accuracy • Better than 0.025 mm on parallel surfaces
• Better than 0.100 mm on wedge angles of up to 10°
Tip composition
Elastomer bead swollen with an ethylene glycol and distilled water solution
In use tip life
1-5 shifts – dependent on environment
Ready to use tip life
7 days when stored in a rack with protective cap
Tip shelf life
12 months minimum
Measurement method
Point measurement of near parallel surfaces and wedges up to 10°
Probe changing
Fully automated to operate as part of a multi-sensor measurement system


Extended warranty

For peace of mind a 3-year warranty is available for your new CMM products during the first 3 months from purchase. Contact your vendor.

Product information

 

You are currently looking at the RUP1 probe. You may also be interested in learning about the other REVO probes; the RVP vision probe, SFP2 surface finish probe, RSP2 or RSP3 probe range.